KERSHAW® SKYTRIM 75 G3 T

Frame: Welded construction front and rear mainframes. High strength alloy steel superstructure

Dimensions:  

Length = 42’ 3” (includes total length with retracted boom) 

Width = 10’ 

Height = 11’ 6”

Weight: Approximately 28,000 lbs. (12,700 kg)

Engine: Equipped with liquid-cooled 4.4 liter Caterpillar^® diesel engine rated for 131hp (97.9 kW) @ 2200 rpm and compliant with European Union Stage IV and EPA Tier 4 Final regulations. Open engine compartment for maximum accessibility. 

Propel System: Hydrostatic propel motors driving through 20.5:1 wheel drives for individual track control

Tracks: Two 33" flat tracks half urethane 13 tooth drive sprocket, half urethane 12 tooth idler sprocket. Tracks mounted on twin tandem four-wheel system (two tandems per track)

Hydraulic System: Engine driven pump drive. Hydrostatic propel system consists of two closed-loop pumps driving a hydraulic propel motors mounted on 30.5:2 drives. Charge loop filtration. Hydraulic reservoir mounted outside engine compartment with cleanout port and shutoff valve. Equipped with electric emergency pump. Upper structure tilt system and boom up/down system equipped with lock valves.

Electrical System: 24-volt dc negative ground with engine-driven alternator and two 12-volt batteries with 1000 cold-cranking amps each. Equipped with safety electric strobe light. 

Capacities: 

Fuel: 90 gal. (340.7 liters)

Hydraulic: 13 gal. (49.21 liters)

Cab: Equipped with 1 1/4" tinted Lexgard® top, engine instruments, and ergonomic seat. Equipped with light touch hydraulic pilot pressure joystick for extend-lift-swing-tilt boom controls, convex mirror, secondary exit, standard wiper and A/C & Heating console. Heavy duty swing bearing with worm gear drive for maximum tooth engagement. Floor is fully enclosed. Access door is full length tinted Lexgard® with positive latch. 

Boom: Telescoping composite construction with 75 ft. (22.8 m) reach from ground. Telescoping boom driven with #50 chain. Each unit is electrically insulated and tested to ANSI A92.2-2001 Category C standards to 100 kV for maximum operator safety. Equipped with single 24 inch (609.6 mm) diameter carbide-tipped saw turning @ 2800 rpm.

Options: Fire extinguishers, rearview camera and other options available upon request